1- construct a 4"x4"x4" cube with one open end, using Briston board, articulating the edges to aid assembly and design intent.
2- design an integral structure made from plastic drinking straws that positions the cube four inches above an eight inch square base.
When I tried working with my initial idea, it didn't turn out right because I hadn't cut enough paper. However, from that mistake I came up with the design that I ended up going with. Below are two thumbnail models for that cube. The one of the left is made with regular printing paper and the one of the right is made with Bristol. The one made out of Bristol was to see if the cube design would still work since it is thicker paper.
After the thumbnails, the next step was to do it in full scale. Below is my test cube for the actual size, along with the straws. The tape was just a quick bind to get my idea across, as well as, a way to change it if something wasn't working right without having to use more Bristol. Bristol isn't expensive but it's not cheap either!
Below is my final product. My intent/theme was angles. I decided to go with a trapezoid shape for the sides. Then I used the straws to mirror the trapezoidal shape. I used purple straws because of the straw choices I had (purple, blue, yellow & orange), I was torn between blue and purple. I would have naturally gone with the blue- since it's my favorite color- but I decided against it because I didn't want my blue obsession to take over. So purple it was! For the base, I went with styrofoam because I thought it was the best choice to stick the straws in. After that I needed to design something that would help focus the viewer's eye to the opening and going with my angles theme I carved an angle right below the opening.
Once the creation of our project was done, there was a final step. That was to draw our cube. We had to include a 3-D render, a couple of orthographic drawings (plan & two elevations views), and a detail view of a joint or edge. My first drawing (below) is the 3-D render.
My next drawings include the plan view (left) and 3 detailed views (right), which include an altered drawing, a top joint and a bottom joint.
My last two drawings are the two elevation views. I chose the front view and right view.
No comments:
Post a Comment